 |
Latest Specs |
 |
|
|
|
|
Popular |
|
|
|
|
|
The New AC Schnitzer TENSION Concept Car based on the BMW M6
Source: AC Schnitzer
Psychologically, tension means excited expectation or apprehension of a proposed
event which is either particularly desired or feared.
Physically, tension describes a force within a resilient body.
Mechanical tension (symbol s) is the force per surface unit which acts in an imaginary
section plane through a body, a fluid or a gas.
Tension is also the most important instrument of playwrights and authors for motivating
the viewer and reader to watch and read further.
The applicaton of all these different definitions to a single vehicle - viewed
from all aspects - is demonstrated by AC Schnitzer at the IAA 2005 with the Concept
Car:
TENSION
The basis for the extensive conversion could only be one vehicle: the 507 HP BMW
M6, which underwent a performance upgrade as the first development stage. Optimising
the entire engine management system and fitting a new AC Schnitzer exhaust manifold
system with special catalyst, sports rear silencer with chromed tailpipe trims
in right/left combination in "Sports Trim Design" help the TENSION achieve
an incredible 406 kW / 552 HP. The Sports Trim Design will also shortly be included
in the AC Schnitzer sports rear silencer range exclusively for the new BMW M vehicles
.
Even more imposing than the pure engine power is the maximum torque of 540
Nm at 6200 rpm, which pushes the driver back in the seat and catapults the TENSION
explosively to 100 km/h in just 4.5 seconds.
The AC Schnitzer Vmax delimiter means that the acceleration thrust continues to
325 km/h before the speedo needle can relax - where driving conditions allow.
Conversely of course tremendous forces are also necessary to bring the TENSION
back to a standstill. To achieve good deceleration values, development of an
AC Schnitzer high performance braking system was essential. On the front axle
this takes the uncompromising form of an 8-pot fixed caliper with perforated
and vented brake disks in 374 mm diameter and with 36 mm thick brake discs.
On the rear axle, a 4-pot fixed caliper is used in conjunction with the standard
brake discs.
For both acceleration and deceleration, it is the wheels which are permanently
under full load in all manoeuvres. To take account firstly of the safety aspect
and secondly to fulfil the high technical requirements imposed on the new Concept
Car by our engineers, a completely new wheel had to be developed.
The result is the AC Schnitzer "Forged Wheel": a lightweight forged
wheel with bi-colour finish, i.e. it has a part polished, part painted surface.The forged
wheel embodies an apparent contradiction: reduction in weight with at the same
time the largest possible diameters and widths.
The TENSION is fitted with wheels size 10.0J x 20" all round. The offsets
of -12 on the front and -2 on the rear allow tyres of size 285/30 ZR 20 respctively,
of type MICHELIN Pilot Sport 2.
The weight of the front wheel is approx. 10 kg and the rear wheel 10.8 kg.
But the AC Schnitzer Forged Wheels are not reserved exclusively for the TENSION.
From December 2005 this new wheel type will also enrich the AC Schnitzer range
forthe BMW 5-series and 6-series.
In motorsport the right Set Up often makes the difference between first and
second places, and our engineers put particular importance on optimum chassis
set-up. In the AC Schnitzer TENSION, driving dynamics are decisively improved
by the special development of an adjustable AC Schnitzer racing suspension.
As well as lowering by 30 mm in relation to its standard brother M6, the spring
and damper rates have been clearly modified towards sporting performance.
To counter lateral roll movements the AC Schnitzer antiroll bar kits are fitted
to the front and rear axles. A further suspension highlight is the specially
developed strut brace in aluminium- carbon combination, which perfectly prevents
torsion in the vehicle front.
The TENSION body conversion is absolutely breathtaking, and is totally dedicated
to optimising the aerodynamics. A further focal point of the development was
the improvement of the air supply and extraction for the power plant and braking
system.
The redesigned bonnet of the AC Schnitzer TENSION reveals at first sight -
through its striking power bulge and large air outlets - that it conceals an
extremely powerful engine which requires maximum cold air flow especially at
full load.
Another totally new development is the front skirt which makes the TENSION
look even lower and further increases downforce on the front axle at high speeds.
Its large air intake provides additional cooling for the engine and front brakes,
and gives the TENSION its unmistakeable visual expression.
To provide additional venting for the V10 engine,large air outlet openings
have been provided in the new front wings, where the 3 chromed ribs and LED
flashers are reminiscent of a shark's mouth.
Adequate air flow is essential for the TENSION to develop its full potential
not only in the front of the car: this principle naturally also applies to the
rear .
Consequently air ducts for the rear brakes have been worked into the striking
side skirts; these skirts not only give the TENSION a more elongated appearance
but also ensure a harmonious transition to the huge rear .
The rear skirt accommodates not only the twin exhaust system made totally of
stainless steel with chromed Sports Trim tailpipes but also a unique underfloor
wing construction with diffuser .
The driver of the AC Schnitzer TENSION has the option of actively changing
the vehicle aerodynamics to suit his needs. This is achieved through two interchangeable
carbon diffusers which meet the differing needs for downforce on a track or
when driving on country roads . The fast action aluminium catches mean that
this conversion can be made effortlessly by the driver and the unused diffuser
can be carried in a special holder in the boot so conversion can be spontaneous
.
The same applies also to the rear wing of the TENSION. This too was designed
as a mobile option for the track and has its place either in the boot or, using
fast action catches, on the specially redesigned boot lid.
The boot lid of the TENSION is a real eyecatcher even without the rear wing
. In contrast to the standard car, it comes without integral rear spoiler ,
giving smoother lines to the vehicle rear.
The body concept , which makes the TENSION 25 mm wider on each side, is complemented
by the AC Schnitzer sports mirrors and the extravagant two-colour paint in Magic
Orange Metallic with Carbon Grey .
The AC Schnitzer engineers are currently planning to include in the range a
"softened" version of the TENSION aerodynamic concept for the M6,
which is now in development.
The interior of the AC Schnitzer TENSION is a combination of developments from
the AC Schnitzer range which are available for many BMW models, and special
one-off products . The latter include amongst others the racing seats in leather
with AC Schnitzer logo and the carbon interior trim in Magic Orange . The 3-spoke
airbag sports steering wheel in leather is also fitted. The selector gaiter
and handbrake handle are finished in Alcantara with black seams . The arm rests
in the doors and on the centre console are finished in Magic Orange leather
to match the paintwork. Velours foot mats with embroidered TENSION logo complete
the interior. The aluminium accessories consisting of pedal set, foot rests,
handbrake handle and a cover for the controller of the "i-Drive" system
are however an established part of the AC Schnitzer range. |
|
|
|
|
Login |
|
|
|
|
|
Poll |
|
|
|
|
|
The database can be found here |
|
Latest Pictures |
|
|
files: 4421
albums: 223 (latest)
categories: 56
5 latest additions:
|
|
